Can't fish Ethernet? Use "invisible" fiber instead
1 comments
- Points6
- Comments3
1 comments
Story details from Hacker News ↗ · linked article on momandpop.network.
Can't fish Ethernet? Use "invisible" fiber instead was first seen on Hacker News · Front page on Nov 2, 2026. Since then it has appeared in 6 checks on 1 different day. Its best position was #24 of 30, reached on Nov 2, 23:37 UTC. It dropped off the list after Nov 2, 23:37 UTC.
Position on Hacker News · Front page at every check (lower is better).
Best rank per day (UTC).
Platform metric as reported by Hacker News.
A few top-level comments from Hacker News, shortened. Read the full thread on Hacker News.
This is how my apartment complex retrofitted all 300ish units with AT&T fiber. Fiber runs from your building's telecom room to a small hole they drilled above everyone's front door, then along baseboards and around door jambs until it reaches ~the center of the unit (concrete walls...) in the living room. It is…
I confess, I've read this twice and I don't really get what's going on here; and I have both MoCA and Powerline going on in my house as well, so I'm like -- why not one of those?
If your CAT6 is down to 100 Mbps, check that all the conductors have been properly crimped into the connector -- or consider re-crimping. It's possible the building has shifted and damaged the fished cable, but it's more likely the problem is with the connector(s).
Archived daily, weekly and monthly lists that include this entry.
Not at the moment. It was last on the list on Nov 2, 23:37 UTC, after 1 day of trending.
#24 on Hacker News · Front page, on Nov 2, 23:37 UTC. Trendoday checks this list every 15 minutes.
It was first seen on Nov 2, 2026 and has been on the list on 1 day (6 checks) since.
6 points and 3 comments; submitted by _mpn_ on Nov 2, 2026.