How to read codes from (many) IR remote controls with as little code as possible
1 comment
- Points4
- Comments1
1 comment
Story details from Hacker News ↗ · linked article on bitbanksoftware.blogspot.com.
How to read codes from (many) IR remote controls with as little code as possible was first seen on Hacker News · Front page on Nov 15, 2026. Since then it has appeared in 26 checks on 1 different day. Its best position was #13 of 30, reached on Nov 15, 15:28 UTC. It dropped off the list after Nov 15, 21:13 UTC.
Position on Hacker News · Front page at every check (lower is better).
Best rank per day (UTC).
Platform metric as reported by Hacker News.
A few top-level comments from Hacker News, shortened. Read the full thread on Hacker News.
I actually did this too, with a lot of different remotes, in micropython on a plain pi pico -- quite fast enough. Different remotes use different formats, a lot of them repeat the actual data twice. Most interesting were the remotes for our minisplits, which tranmit the whole state for the minisplit, followed by a…
Archived daily, weekly and monthly lists that include this entry.
Not at the moment. It was last on the list on Nov 15, 21:13 UTC, after 1 day of trending.
#13 on Hacker News · Front page, on Nov 15, 15:28 UTC. Trendoday checks this list every 15 minutes.
It was first seen on Nov 15, 2026 and has been on the list on 1 day (26 checks) since.
4 points and 1 comment; submitted by speckx on Nov 11, 2026.